Meet Eagle KlawThe world’s only multi-point tension retainer that grips your car floor with the strength of an eagle's claw.No need to drill or cut holes in the floor.It only takes about 3 minutes to fasten your car mat. Just step on it! Here's how… Installation is a Breeze...Make sure the car floor has sufficient padding or space under the carpet at the place of Eagle Klaw anchor installation before making holes in the mats.Put the cap through the hole, push the sliding washer up onto the cap post. Screw the cap into the anchor until the end of the cap post is even or flush with the bottom of the anchor.Place the car mat where you want it to stay. Pre-engage the spikes by pushing the fastener down or tapping on the cap with a hammer slightly to prevent rebound.Stomp down on the cap or use a hammer to ensure vertical movement. And here’s why… The car mat is sandwiched between the cap and the sliding washer when tightened into the anchor.Use the optional 3/8" Cutter if your mat doesn't have holes.When you step on the cap or hit it with a hammer, the anchor bends inward and the spikes penetrate the carpet on a slight outward angle. When released, the fastener springs back flat and the spikes return to a vertical position, gripping the carpet.The five-legged design provides optimal force distribution and ensures that all spikes are inserted at the same time. The fastener doesn’t move if you push the mat hard in any direction. Due to the spike design, there will be no visible holes in the carpet if you have to remove the anchor, making it minimally intrusive…